Finishing The Installation - Kichler Spyn LED 52 Manual De Instrucciones

FINISHING THE INSTALLATION

NOTE: Before continuing , make sure the power is disconnected by turning
o the circuit breaker of removing the fuse at the circuit box.
Step 1. Remove one of the two shoulder screws in the mounting bracket. Loosen
the second shoulder screw without fully removing it. (Fig. 13)
Step 2. Assemble canopy by rotating key slot in canopy over shoulder screw
in mounting bracket. Reinstall the shoulder screw that was previously removed,
then retighten two shoulder screws securely.(Fig.14)
Step 3. Securely attach and tighten the canopy hole cover over the shoulder
screws in the mounting bracket utilizing the keyslot twist-lock feature. (Fig. 15)
Mounting Bracket
Shoulder Screw
Fig. 13
Canopy
Shoulder Screw
Fig. 14
Shoulder Screw
Canopy Hole Cover
Fig. 15
52" Spyn LED 11