Finishing The Motor Installation - Kichler Bead 54 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

MAKE THE ELECTRICAL CONNECTIONS

Step 4. If your outlet box has a ground wire (green or bare copper) connect

Step 4.

If your outlet box has a ground wire (green or bare copper) connect

it to the fan ground wires : otherwise connect the fan ground wire to the

mounting bracket. Secure the wire connection with a plastic nut provided.

After connecting the wires, spread them apart so that the green and white

wires are on one side of the outlet box and black and blue wires are on the

other side.

NOTE: Carefully tuck the wire connections up into the outlet box.

NOTE:

Carefully tuck the wire connections up into the outlet box.

NOTE:

NOTE: Fan must be installed at a maximum distance of 30 feet from the

Fan must be installed at a maximum distance of 30 feet from the

transmitting unit for proper signal transmission between the transmitting

unit and the fan's receiving unit.

FINISHING THE MOTOR INSTALLATION

Step 1. Remove the motor assembly from the hook of the ceiling mounting

Step 1.

Remove the motor assembly from the hook of the ceiling mounting

bracket and push up the motor assembly until the two screws on the ceiling

mounting bracket are engaged with the slot holes on the canopy of the

motor assembly. Rotate the motor assembly slightly until the two screw

heads are in the slot holes. Install the two screws previously removed and

tighten all four screws. (Fig. 11)

Step 2.

Step 2. Push the canopy trim ring up until it locks into place at the top of the

Push the canopy trim ring up until it locks into place at the top of the

canopy. (Fig. 12)

10 | KICHLER.COM

Fig. 11

Canopy Trim Ring

Fig. 12

Tabla de Contenido

Tabla de contenido