Operation Instructions; Connection The Compressor; Load And Unload The Fastener; Depth Of Drive Adjustment - Kyocera TJEP GRF 34/100 Instrucciones De Seguridad Y Funcionamiento

operator shall consult a qualified health profes-
sional regarding overall activities.
• While using the tool, the operator shall adopt a
suitable but ergonomic posture. Maintain secure
footing and avoid awkward or off-balanced pos-
tures.
• Hold the tool with a light, but safe, grip because
the risk from vibration is generally greater when
the grip force is higher.
• Residual risks relating to repetitive work hazards
such as duration of use in respect to working posi-
tions and forces may exist. It is advised to consult
EN 1005-3 and EN 1005-4 for such information.
• Slips, trips and falls are major causes of workplace
injury. Be aware of slippery surfaces when operat-
ing the tool.
• Proceed with additional care in unfamiliar sur-
roundings. Hidden hazards may exist, such as
electricity or other utility lines.
• If the tool is used in an area where there is static
dust, it may spread the dust and cause a hazard.
If possible turn the exhaust (E) away from these
areas.
• Where dust hazards are created, the priority shall
be to control them at the point of emission.

Operation instructions

Connecting the compressor
• Connect the coupling on the air hose to the tool air
plug (H).

Load and unload the fastener

• Connect the compressor before you load the
fasteners. If you load the fasteners before the
compressor is connected, the fasteners may be
shoot out accidentally. Point the nozzle away from
any personnel and keep your finger away from the
trigger when loading the fastener.
• Load fasteners into tool with "2-step" magazine:
· Slide the fastener strip into the magazine (I)
until the fastener strip has passed the fastener
stopper (C).
· Pull the pusher (D) until it is beyond the stopper
(C).
· Gently release the pusher (D) to engage the
fastener strip and feed it into the nose piece.
174
• Unload fasteners from tool with "2-step" magazine:
· Press the release lever on the pusher (D) and
tilt the tool to slide the fastener strip to the rear
end of the magazine.
· Press the fastener stopper (C) and slide out the
strip.
• Load fasteners into tool with "3-step" magazine:
· Pull the pusher (D) to the rear until it is locked
to the magazine at rear position
· Slide fastener strip into the magazine (I).
· Gently release the pusher (D) to push the
fasteners into the nozzle
• Unload fasteners from tool with "3-step" magazine:
· Pull the pusher (D) to rear locking position.
· Slide the fasteners out of the magazine (I).

Depth of drive adjustment

• The tool can be equipped with a depth of drive
adjustment (A). Test the depth of drive on scrap
piece before you start your work.
• Turn the knob (A) or use hex key to adjust the
depth of drive.
• Repeat above procedure until you find your de-
sired depth of drive setting.

Operating the tool

• The tool can equipped with one of the below men-
tioned triggers (F):
Single sequential trigger
• To actuate the fastenerer, depress the safety
bracket against the workpiece, and pull the trigger.
• To actuate the fastenerer again, you will need to
release the safety bracket fully and release the
trigger before repeating the above procedure.
Bump fire
• Activate the trigger, bump the safety bracket
against the workpiece, and a shot will be
fired.