ASROCK H670 PG Riptide Manual De Instrucciones página 40

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 88
C
B
A
C
B
A
C
B
A
C
B
A
C
NUT2
20
o
NUT1
Step 3
Move the standoff based on the
module type and length.
The standoff is placed at the nut
location C by default. Skip Step 3
and 4 and go straight to Step 5 if you
are going to use the default nut.
Otherwise, release the standoff by
hand.
Step 4
Peel off the yellow protective film on
the nut to be used. Hand tighten the
standoff into the desired nut location
on the motherboard.
Step 5
Gently insert the M.2 (NGFF) SSD
module into the M.2 slot. Please
be aware that the M.2 (NGFF) SSD
module only fits in one orientation.
Step 6
Tighten the screw with a screwdriver
to secure the module into place.
Please do not overtighten the screw
as this might damage the module.
H670 PG Riptide
37

Publicidad

Tabla de contenido
loading

Tabla de contenido