All manuals and user guides at all-guides.com
12
PanelView 600 Terminals
Connecting AC Power
The electrical rating for the PanelView 600 terminal is shown below.
Terminal Type
PV600
The PanelView 600 terminal is an IEC 1131-2 Equipment Class I device and
requires you to connect the
ATTENTION
!
ATTENTION
!
To connect AC power to the PanelView 600 terminals:
1. Secure the AC power wires to the L1 and L2N screws on the terminal block.
2. Secure the Earth Ground/Protective Earth wire to the
block.
ATTENTION
!
41061-004-01(D)
Supply Voltage
85 to 264V ac, 47 to 63 Hz
(Protective Earth) terminal to an earth conductor.
• The PanelView 600 terminal is designed for safe use when
installed in a suitably rated NEMA Type 12, 13, 4X (indoor
use only), IP54 or IP65 enclosure.
• Do not apply power to the terminal until all wiring
connections have been made. Failure to do so may result in
electrical shock.
Explosion Hazard - Do not connect or disconnect equipment
while circuit is live unless area is known to be non-hazardous.
Improper wiring of the power terminals may result in
voltage at the communication connector shells. Refer to the
following figure when wiring.
Power Consumption
60 VA maximum
screw on the terminal