Maintenance; Preventive Maintenance; Cleaning Activated Carbon Fi Lters On Customer Side; Defrosting Refrigerated Drawers - LIBERO POINT NERLP2 Instalación Uso Y Mantenimiento

I7

Maintenance

The inspection and maintenance intervals
depend on the actual machine operating
conditions (total hours of use) and ambient
conditions (presence of dust, damp, etc.),
therefore precise time intervals cannot be
given. In any case, careful and periodical
machine maintenance is advisable in order to
minimize interruptions of the service.
It is advisable to stipulate a scheduled
preventive maintenance contract with the
After-Sales Service.
ATTENTION!
Do not make modifi cations to the
parts supplied with the machine.
Any missing or faulty parts must
be replaced with original parts.
I7.1

Preventive maintenance

If required, the After-Sales Service can be
contacted to arrange an equipment technical
maintenance schedule.
I7.2 Cleaning activated carbon fi lters on
customer side
Described below are the operations necessary
to clean the activated carbon fi lters placed in
Zone D (fi g. 2):
• Switch the appliance off by keeping the button
"S" pressed for about 2 seconds.
• Remove the power plug from the main
panel the appliance is connected to.
• Unscrew the pins 1/4 of a turn "
remove the covering panels "O" pulling down
slightly;
• Unscrew the pins 1/4 of a turn "
remove the covering panels "P" pulling down
slightly.
• Undo the screw " N" and remove the fi lters
"Q" from their seats;
ATTENTION! ATTENTION!
In this phase the machine's In this phase the machine's
extraction fan can be seen. To extraction fan can be seen. To
avoid the risk of damage to the avoid the risk of damage to the
appliance or shearing of limbs, appliance or shearing of limbs,
it is strictly forbidden the place it is strictly forbidden the place
any kind of object inside the fan. any kind of object inside the fan.
The Manufacturer declines any The Manufacturer declines any
responsibility if this requirement responsibility if this requirement
is not respected. is not respected.
All manuals and user guides at all-guides.com
•
•
•
•
•
I7.3
The humidity inside the drawer can condense,
forming frost which reduces the cooling
capacity. To defrost the drawers, proceed as
follows:
•
•
•
•
I8
At the end of the product's service life, make
sure it is not dispersed in the environment. The
equipment must be disposed of in compliance
with the current regulations in the country of
use.
All metal parts are in recyclable steel and
removable. Plastic parts are marked with the
letters of the material.
The symbol
R" and
it should not be treated as domestic waste,
but must be correctly disposed of in order to
prevent any negative consequences to the
M" and environment and the health of people. For
further information regarding the recycling of
this product, contact the agent, local dealer,
after-sales service or the local body responsible
for waste disposal.
47
Wash and rinse the fi lters manually;
Then leave them to dry completely;
Refi t the fi lters;
Secure the fi lters by retightening the screws
"N";
Refi t all the other parts.

Defrosting refrigerated drawers

Remove the products from the drawer and, if
necessary, place them in another refrigerator
so that they stay cold;
Switch off the drawer as described in par.
Switching off refrigerated drawers;
Leave the drawer open and wait for the ice
to melt;
Clean and dry the drawer thoroughly.

Machine disposal

K
on the product indicates that
G
I4.2