Publicidad
Idiomas disponibles
Idiomas disponibles
!
Never cover or conceal bicycle lights. Always make sure the bicycle lights are correctly adjusted. In
general, the prescribed mounting height ranges between about 16" to 48". For details consult the High-
way Code or DMV Handbook or inquire with a local bicycle specialist retailer. Make sure your lights are
positioned and adjusted in a way to ensure they do not blind oncoming traffic.
5 Package content
Headlight | Mains charger for USB | USB cable to micro USB | Handlebar bracket | Short & long screw |
screw socket | Mounting instructions
6 Assembly!
Make sure that the headlight is mounted to the handlebar.
Place the enclosed rubber ring around the handlebars. Select the locking screw and locking knob to fit
the handlebar diameter and screw them into the handlebar bracket. Place the handlebar bracket over the
rubber ring with the locking knob facing the saddle. Join the brackets under the handlebar and fix them
with the locking screw.
!
Please note: The locking knob can be used as a short or long version (simply turn as required)!
20
Fixing ring
Rubber ring
!
Insert the headlight vertically from above into the headlight bracket and press down firmly.
It audibly engages in the locking ring. Make sure it is firmly seated in place. To remove the
headlight, turn the locking ring clockwise, hold the headlight firmly and pull it upwards. We do
not assume any liability in case of drop damage, e.g. because the headlight was not held in place
while releasing the locking ring. If the assembly situation on the bicycle only allows the locking
knob to point away from the cyclist rather than towards him/her, use a screwdriver to unbolt the
bracket on the underside of the headlight, turn by 180° and then fasten again.
Short screw (30 mm)
Long screw (55 mm)
21
Publicidad
