Slime Flat Tire Repair Kit Pro-Serie Manual De Instrucciones página 2

CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE INFLATOR ON A HARD,
CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in "accessory" or
"on" position. Please make sure emergency brake is set and car is in park.
2. Always ensure the valve connector is fully seated to depress the core of the valve stem
for proper inflation.
2. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
3. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.
4. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings.
Be careful not to inflate items beyond their capacity.
5. While operating, never block the inflator input or output.
6. Keep inflator out of reach of children.
7. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older
8 amp cigarette lighter receptacles.
FLAT TIRE REPAIR (AIR + SEALANT) INSTRUCTIONS:
Check your tire warranty prior to installation of this product.
NOTE: Seals punctures up to 1/4 in. (6mm) in tread area for flat tire repair.
Correct tire pressure can be found in your vehicle's owner's manual or driver side doorjamb.
Drive two miles with speeds less than 25 miles per hour to disperse sealant throughout the tire,
allowing it to seek out and seal the puncture. Recheck tire pressure to verify that the puncture has been
sealed.
Slime® provides a quick emergency repair. Treated tires should be repaired by a qualified tire
professional at the earliest opportunity to ensure safety and proper cleaning of tire pressure sensor, if
so equipped. We recommend treated tire be repaired within 3 days or 100 miles after use of Slime Tire
Sealant, whichever comes first. Advise tire professional of product use.
1
Select AIR + SEALANT.
NOTE: Lay Flat Tire Repair Kit on the ground facing
upward.
2
Screw air/sealant hose onto tire's valve stem.
3
Plug inflator into 12 volt accessory power outlet. Do not run vehicle
while inflator is operating. Your vehicle may need to be in accessory or on.
Please make sure emergency brake is set and car is in park.
4
To set the Inflate Right™ Technology, press the + or - buttons to desired
pressure. The gauge will flash three times and return to current tire
pressure. Holding the + or - button will enter into fast-setting mode. Hold
and press the power button for 3 seconds to initiate air/sealant mode.
Once in air/sealant mode, LED screen will flash three times. Press the
power button to start inflation. When the pressure gauge reaches the
pre-set value, the inflator will automatically stop inflation. Once desired
tire pressure is reached, disconnect the air hose and unplug the power
cord. The ON/OFF button can be used to override the pre-set pressure
value if required.