First Aid; Warranty Information - Slime Flat Tire Repair Kit Pro-Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SEALANT CARTRIDGE REMOVAL INSTRUCTIONS:
1
Unwrap air/sealant hose.
TROUBLESHOOTING:
Inflator fails to operate when plugged in:
1. Check the power plug and push it firmly into the receptacle, twist back and forth..
2. Check receptacle and plug terminals for dirt, or debris. (Use a non-conductive probe, not fingers or
metal).
3. Check vehicle power outlet fuse. It should be 15 amps minimum.
4. Check the fuse. It may have blown: 12V fuse is located in the plug adaptor: unscrew the tip, remove
fuse, and inspect. If necessary, replace fuse with 15A 250V 5mm x 20mm.
5. Check to see if the pre-programmed INFLATE RIGHT digital gauge is set to a lower PSI than your tire
currently is reading (i.e., the digital gauge is set to 15psi but your tire is at 20psi; in this scenario, the
inflator will not turn on) and set the PSI to the correct tire pressure. Refer to Inflate Right™ Technology
operating instructions.
Inflator runs but does not inflate:
1. Be sure the air hose valve connector is fully secured on the tire valve.
2. Check tire for leaks, and check hose for breaks and leaks at fittings and check valve core for damage.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for 25 minutes.
2. The voltage may be too low. Check the condition of your vehicle's battery.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air to
leak out when trying to inflate. In the event this situation occurs, you will have to jack up the tire prior
to inflation. Dispose of this product at an e-waste recycling collection point or facility. Do not place in
the trash or standard recycling receptacle.
WARNING: HARMFUL OR FATAL IF SWALLOWED. IRRITANT TO SKIN AND EYES. Avoid
ingestion and inhalation. Avoid eye and skin contact. Wash hands after use. Use only as
directed. KEEP OUT OF REACH OF CHILDREN.
FIRST AID: In case of eye contact, rinse eyes for 15 minutes with cool water, lifting eyelids
occasionally. If on skin, wash with soap and water. If inhaled, seek fresh air. If ingested,
DO NOT INDUCE VOMITING; drink plenty of water and contact a physician or hospital.
Contains ethylene glycol and natural latex rubber.
Call ChemTel: +1-800-255-3924 or 1-813-248-0573
Reference product name: PART#50150 or #10179 V1D (Refill)
Sealant cartridge refills available • PART# 10179
WARRANTY INFORMATION: www.slime.com/warranty
QUESTIONS OR COMMENTS: Call 1-888-457-5463 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime
®
is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.
2
Lift cartridge cover.
3
Rotate cartridge to upright
position.
4
Pull cartridge out
horizontally.

Publicidad

Tabla de contenido
loading

Tabla de contenido