Slime Flat Tire Repair Kit Pro-Serie Manual De Instrucciones página 3

AIR ONLY INSTRUCTIONS:
The AIR ONLY mode can also be used for bicycles, sports balls, rafts and other inflatables.
IMPORTANT! When using the supplied inflatable adapters, the valve
depressor adapter (Fig. X) must be used in conjunction with the inflatable
adapters. Failure to use the supplied valve depressor adapter with inflatable
adapters will result in over-pressurization and failure of the Flat Tire Repair
Kit. To install, remove the valve depressor adapter assembly from the back
of the Flat Tire Repair Kit. Unscrew the Presta valve adapter and set aside.
Thread the valve depressor adapter into the air hose of the Flat Tire Repair Kit
(Fig. Y) until fully seated. Thread on the desired inflatable adapter until snug
and inflate item.
USING THE DEFLATE BUTTON
The PRESSURE RELEASE ensures optimum PSI pressure. Push the area to
deflate the tire if it has been overinflated, or if there is too much air prior
to inflation. Check your gauge for the desired PSI level. NOTE: Correct
tire pressure can be found in your vehicle's owner's manual or driver side
doorjamb.
1
Select AIR ONLY.
NOTE: Lay Flat Tire Repair Kit on the ground facing
upward.
2
Screw air/sealant hose onto tire's valve stem.
3
Plug inflator into 12 volt accessory power outlet. Do not run vehicle
while inflator is operating. Your vehicle may need to be in accessory or
on. Please make sure emergency brake is set and car is in park.
4
To set the Inflate Right™ Technology, press the + or - buttons to desired
pressure. The gauge will flash three times and return to current tire
pressure. Holding the + or - button will enter into fast-setting mode.
Press the power button to start inflation. When the pressure gauge
reaches the pre-set value, the inflator will automatically stop inflation.
Once desired tire pressure is reached, disconnect the air hose and unplug
the power cord. The ON/OFF button can be used to override the pre-set
pressure value if required.
Fig. X
Fig. Y