Special Features; Product Description; Before First Use - GYMFORM POWER BURN Manual De Instrucciones

• Do not connect the metal snap fasteners or
electrodes to any other object.
• Do not modify the device.
• Use only the electrodes supplied by Industex.
• Do not attach two electrodes together.
• If any of the electrodes are not attached
properly, you will notice an itching sensation.

SPECIAL FEATURES

- Practical and compact
technology.
- Stylish and ergonomic design.
- Wireless units with oscillating dual-head
technology.
- Electrodes with super-adhesive conducting gel.
- Three highly touch-sensitive control buttons
(MODE, ON/+ and OFF/-).
- Six LED lights that indicate the selected
programme.
- Each programme offers 10 intensity levels from
beginner to advanced.
- Six very advanced exercise programmes.
- Automatically switches off after 10 minutes to
complete the recommended amount of exercise.
- Automatically switches off after three seconds
if turned on but not used and after 10 seconds if
one of the electrodes is not in direct contact with
the skin.
COMPONENTS:
- 1 Detachable Gymform® POWER BURN unit
- 2 Round, self-adhesive electrodes
- 2 Self-adhesive electrodes for abs
- 1 Instruction manual
- 1 Diet booklet

PRODUCT DESCRIPTION:

1. Gymform® POWER BURN unit
2. Round, self-adhesive electrodes
3. Self-adhesive electrodes for abs
4. Programme indicators
5. ON/+ button to turn on and increase intensity
6. OFF/- button to turn off and reduce intensity
7. Mode button to change programmes
8. Battery compartment

BEFORE FIRST USE

1. Two 3 V CR2032 batteries are required to use
the Gymform® POWER BURN. Remove the
battery compartment (8) and insert two batteries
in the position indicated in the diagram inside the
compartment. Insert the battery compartment
back into the unit (1). See Picture 2.
2. The Gymform® POWER BURN unit is made
up of two parts joined by a cable (See Picture 1).
microprocessor
Ensure that they are properly connected.
Attach the unit (1) to each self-adhesive
electrode using the snap fasteners and make
sure it is properly attached. To work on your abs,
use the self-adhesive electrodes for abs (3). For
all other muscles on your body, use the round,
self-adhesive electrodes (2). See the table
below.
3. Remove the protective plastic backing from
the self-adhesive electrode. (Keep the plastic
backing to protect the electrodes after using
them.)
4. Place the self-adhesive electrodes on the
parts of the body to be treated.
Parts of the Body to Work Out Using the
Gymform® POWER BURN:
Each Gymform® POWER BURN device allows
you to work out two adjacent muscles at the
same time:
Use the self-adhesive electrodes for abs (3) to
simultaneously work the:
1. Upper abs
2. Middle abs
3. Lower abs
Use the round, self-adhesive electrodes (2) to
simultaneously work the:
4. Chest
5. Obliques
6. Glutes
7. Trapezius
5