Uline H-2888 Guia De Inicio Rapido página 2

Figure 2
Figure 3
Figure 4
PAGE 2 OF 6
ASSEMBLY CONTINUED
4. Align the second double holed bullnose bench slat
on the top set of pre-drilled holes on the bench base
backrest. Loosely attach double holed bullnose
bench slat to the bench bases with the 3½" lag
screws and washers using the power drill and 7/16"
socket bit (will tighten later in step 7). (See Figure 2)
5. Align three single hole bench slats on the pre-drilled
holes of the bench base seat. Loosely attach the
single hole bench slats with the 3½" lag screws and
washers using the power drill and 7/16" socket bit (will
tighten later in step 7). (See Figure 3)
6. Align the remaining two single hole bench slats on the
pre-drilled holes of the bench base backrest. Loosely
attach the single hole bench slats with the 3½" lag
screws and washers using the power drill and 7/16"
socket bit (will tighten later in step 7). (See Figure 4)
7. Make sure the bench is square and tighten all lag
screws.
1-800-295-5510
uline.com
NOTE: H-2565 Mounting hardware sold
separately.
0621 IH-2888