Husqvarna DM 540i Manual De Usuario página 16

2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To connect the battery to the battery
charger
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger. (Fig. 19)
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 20)
4. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 21)
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To use the auxiliary handle
(Fig. 22)
1. Turn the handle counterclockwise to release it.
2. Move the handle around the spindle shaft to an
applicable operation position.
3. Turn the handle clockwise to lock it. Tighten fully.
To use the product handheld
WARNING:
from a ladder. If the drill bit becomes
blocked, there is a high risk of fall injury.
(Fig. 23)
1. Always use a drill bit with a maximum diameter of 75
mm with handheld drill operation.
Operation
Handheld
Drill stand
16
Do not operate the product
Drill bit diameter, mm
25-75
25-100
WARNING:
blocked, a reaction will occur. Larger
diameter of the drill bit gives larger
reaction.
2. Lock the auxiliary handle tightly in position before
you operate the product. Refer to
auxiliary handle on page 16 .
To prepare the product for dry drilling
WARNING:
drill, which can cause injuries if breathed in.
Use approved breathing protection.
WARNING:
vacuum cleaner. Use only designated dust
extractors for hazardous dust. Refer to
extractor on page 23 for minimum
properties.
1. Attach the dust extractor connector to the mounting
thread on the product.
2. Attach the dust extractor to the dust extractor
connector. (Fig. 24)
3. Start the dust extractor.
To prepare the product for wet drilling
CAUTION:
maximum water pressure is not too high.
Technical data on page 21 .
Refer to
CAUTION:
prevent dirt blockage in the water system.
CAUTION:
supply coupling. Speak to your dealer for
more information.
1. Attach the water connector to the mounting thread
on the product. (Fig. 25)
2. Connect the Gardena
valve to the water connector. (Fig. 26)
3. Open the water system and adjust the water flow
with the valve. Set the water pressure to remove all
waste material from the drill hole. (Fig. 27)
To prepare the product for inverted
drilling
WARNING:
with a sealing disc and a rubber washer
during inverted drilling. Water that enters the
If the drill bit becomes
To use the
Dust is made when you
Do not use a house-hold
Make sure that the
Use only clean water to
Use only an approved water
®
male coupling with water
Always use a slurry ring
1567 - 002 - 18.10.2021
Dust