Assembly; Operation; Bluetooth ® Wireless Technology - Husqvarna DM 540i Manual De Usuario

Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, disconnect the battery
from the product.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 18 .
3. Make sure that there is no oil on the handles.
4. Make sure that the work area is clean and bright.
5. Use personal protective equipment. Refer to
Personal protective equipment on page 13 .
6. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
7. Install and fully tighten the auxiliary handle only
when you use the product handheld. Refer to
the auxiliary handle on page 16 .
8. Use a dust extractor when you do dry drill
operations. Refer to
drilling on page 16 .
9. Use the water system when you do wet drill
operations. Make sure that the water system is not
To prepare the product for wet
damaged. Refer to
drilling on page 16 .
10. Do a function check. Refer to
before you operate the product on page 15 .
To do a function check before you operate the
product
1. Do a check of the gear selector (A) to make sure that
it operates correctly and that it is not damaged.
To start the product on page 17 .
Refer to
2. Do a check of the control panel (B) to make sure that
it operates correctly. Refer to
control panel on page 13 .
1567 - 002 - 18.10.2021
Before you assemble the
To prevent accidental start
Read and understand the
Maintenance
To prepare the product for dry
To do a function check
Functions of the

Assembly

To attach the product to a drill stand
• To attach the product to a drill stand, refer to the
manual for the drill stand.
• Use only with approved HUSQVARNA drill stands.
Refer to

Operation

3. Do a check of the power trigger (C) to make sure
that it operates correctly and that it is not damaged.
Refer to
4. Charge the battery (D) and make sure that it is
correctly attached to the product. Refer to
the product on page 17 .
5. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
6. Make sure that the drill bit stops when you release
the power trigger. (Fig. 18)
Bluetooth
Products with built-in Bluetooth
can connect to mobile devices and enables additional
functions from HUSQVARNA connect.
The symbol for
on when your mobile device is connected to the product.
(Fig. 6)
To use embedded connectivity with
To use
fleet
Note:
This part is applicable only for products
supplied with embedded connectivity.
Note:
Radio transmission by the Bluetooth
will be enabled on the first time of connection to a
battery, and stay on after that.
1. Download the Husqvarna Fleet Services iOS or
Android app Husqvarna Fleet Services.
2. Go to Husqvarna Fleet Services website https://
fleetservices.husqvarna.com for more information.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
CAUTION:
Read the operator's manual
for the drill stand carefully.
Applicable drill stands on page 23 .
To examine the power trigger on page 13 .
®
wireless technology
®
wireless technology
®
Bluetooth
wireless technology comes
To start
®
function
15