Bosch Professional GCM 12 SD Manual Original página 48

OBJ_BUCH-1130-002.book Page 48 Thursday, July 1, 2010 11:44 AM
48 | English
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the
52°
standard mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
38°
Settings
Vertical bevel angle
Ceiling strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
1 609 929 X01 | (1/7/10)
Placed
against
the fence
52°
0°
Left side Right side
45° right 45° left
Bottom edge Bottom edge
against the against the
fence fence
... to the right ... to the left of
of the cut the cut
45° left 45° right
Bottom edge Bottom edge
against the against the
fence fence
... to the right ... to the left of
of the cut the cut
Lying flat
on the
saw table
33.9°
Left side Right side
31.6° right 31.6° left
Upper edge Bottom edge
against the against the
fence fence
... to the left of ... to the left of
the cut the cut
31.6° left 31.6° right
Bottom edge Upper edge
against the against the
fence fence
... to the right ... to the right
of the cut of the cut
Bosch Power Tools