Maintenance And Cleaning; Environmental Protection - Würth AL 30-SD-LI Traducción Del Manual De Instrucciones De Servicio Original

AL 30-SD.book Seite 9 Donnerstag, 20. April 2017 4:22 16
Charging ON FLASH- Rapid charging active.
ING
Full OFF ON Trickle charging active.
* If no LED lights up after inserting or removing the battery while mains voltage is given, send in the charger with the battery
to your Würth after sales service agent. Ensure not to leave the battery inserted in the charger, and do not test another
battery. A defective charger can damage the battery.

Maintenance and Cleaning

Before any work on the machine itself, pull the
mains plug.
The supply cord of this Appliance cannot be re-
placed. If the cord is damaged the appliance should
be discarded.
Always keep the ventilation slots of charger and battery
clean to maintain proper cooling.
If the machine should happen to fail despite the care
taken in manufacture and testing, repair should be car-
ried out by an authorized customer service agent for
Würth power tools.
For all correspondence and spare parts orders, always
include the article number on the type plate of the
machine.
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/partsman-
ager" or ask for a copy at your nearest Würth branch
office.
Warranty
For this Würth machine, we provide a warranty in
accordance with statutory/country-specific regulations
from the date of purchase (proof of purchase by invoice
or delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can only be accepted if the device is sent undis-
assembled to a Würth branch office, your Würth sales
representative or a customer service agent for Würth
power tools.

Environmental Protection

Recycle raw materials instead of disposing
as waste
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
The plastic components are labelled for categorized
recycling.
Subject to change without notice
The charge procedure of a 3.0 Ah battery
is finished after no later than 45 minutes.
The charger switches to trickle charging.
Battery can be kept in the plugged-in charger.
9