LUND Summit Ridge 2.0 Instrucciones De Instalación página 3

10. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Running Board.
Remove plastic plugs or
factory hex bolts (if equipped)
Front
(Fig 1) Passenger/right side
front mounting location
Front
(Fig 3) Passenger/right side front Bracket
Passenger Side Installation Pictured
Page 2 of 5
07-17 TOYOTA TUNDRA CREWMAX
Front
(Fig 2) Passenger/right front mounting location
Front
Fig 4
SR2 RUNNING BOARDS
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
NOTE: (2) Cuts on
corners of Rear
Brackets
NOTE: Round
edges on Center
Brackets
11/27/17 (RA)