Technical Characteristics - PRESIDENT BILL II FCC Manual Del Usuario

7. The unit automatically
0 - the volume knob (1) affects the internal speaker volume.
1 - the volume knob (1) affect the accessory volume
2 - the volume knob (1) affects both the internal speaker
and accessory volume.
Default accessory volume is 0.
7) SCAN SKIP
This function allows to
the SCAN SKIP memory.
First Select then channel to be set.
1. Turn off the unit.
2. Turn on the radio while pressing the AM/FM key (7).
displayed.
3. Use s/t key (3) on the unit or UP/DN buttons on the
microphone (3) to select
4. Press the AM/FM key (7) to
5. Use s/t key (3) on the unit or UP/DN key (3) on the
alternate
microphone to
6. Press the AM/FM key (7) to
menu or press the PTT switch (11) to
7. The unit automatically
On memorize the current channel into the SCAN SKIP
memory. When a channel is stored in the memory,
appears on the display close to the channel number.
OF erase the current channel from the SCAN SKIP memory,
disappears from the display. See the § SKIP on page
11.
Consult the RESET menu.
exits
the menu after 10 seconds.
memorize/erase a channel form
the menu.
validate
the menu.
between On and OF.
confirm and select another
confirm and exit.
exits
the menu after 10 seconds.
8) RESET
Erase
the scan skip memory or
1. Turn off the unit.
2. Turn on the radio while pressing the AM/FM key (7).
displayed.
3. Use s/t key (3) on the unit or UP/DN buttons on the
microphone (3) to
4. Press the AM/FM key (7) to validate.
5. Use s/t key (3) on the unit or UP/DN key (3) on the
microphone to Select
6. Press the AM/FM key (7) to
menu or press the PTT switch (11) to
7. The unit automatically
is
SC erase all the channels stored on the SCAN SKIP memory.
They are now enabled to be scanned (see the § SKIP
page 11).
AL restore all the factory parameters.
A) DC-POWER TERMINAL (13,8 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3,5 mm)
F) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation mode
- Frequency ranges
- Weather channels
- Antenna impedance
15
restore
all factory settings.
select
the menu .
SC or AL.
confirm select
and
confirm and exit.
exits the menu after 10 seconds.
: 40
: AM / FM
: from 26.965 MHz to 27.405 MHz
: 162,400 MHz to 162,550 MHz
: 50 ohms
is
another