Tabla de contenido
Publicidad
Turn on and off
Operation
1.
Slide the locking mechanism on the battery compartment to the
centre position to expose the charge jack.
2.
Plug the AC connector into the appropriate AC power source.
3.
Connect the charger plug into the charge jack on the Zone80 DG
battery pack.
4.
The small LED next to the charge jack flashes indicating that the
Zone80 DG is charging. The LED is on solid when the battery
pack is fully charged.
5.
When the battery pack is fully charged, disconnect the charger
plug from the charge jack.
6.
Slide the locking mechanism to the left position to prevent dirt
from getting into the charging jack.
☞
The battery pack reaches a full charge in approximately 5 hours
if completely empty. A one-hour charge should allow the Zone80
DG to run for a full 8 hours.
Press the Power button to turn the Zone80 DG on or off.
20
en
Publicidad
Tabla de contenido
