Technical Data; Safety Instructions - Hilti GX 90-WF Manual De Instrucciones

4 Technical data

Right of technical changes reserved.
Tool
Weight (including battery)
Dimensions (L x W x H)
Gas can
Gas can type 1
Operating temperature / ambient temperature with
GC 31 gas can
Operating temperature / ambient temperature with
GC 32 gas can
1 Contains: 1-butene, propene
Battery
Rated voltage
Capacity
Energy capacity
Weight
Type of cell
Cell block
Deep discharge prevention
Temperature monitoring
Recoil
Energy-equivalent acceleration, a
Maximum fastener driving rate
Work with interruptions:
Continuous operation:
Suitable fasteners
Nail length
Nail diameter
Magazine capacity
Magazine angle

5 Safety instructions

5.1 Basic information concerning safety
In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
5.1.1 Requirements to be met by users
a) The tool is intended for professional use.
3.7 kg (8.16 lbs)
384 mm x 134 mm x 381 mm
GC 31, GC 32
-5...+45°C (23 °F to 113 °F)
-10...+45°C (14°F to 113°F)
B 7/1.5 Li‑ion
7.2 V
1.5 Ah
10.8 Wh
0.19 kg
Lithium-ion
2
Yes
Yes
Results for 90 x 3.1 mm nail on solid wood (pine)
hw, RMS(3)
1.54 m/s² (1/-0.07)
2 to 3 fastenings per second
1,200 fastenings per hour
50...90 mm
2.8...3.1 mm
75 (max.)
34°
b) The appliance may be operated, serviced and re-
paired only by authorized, trained personnel. This
personnel must be informed of any special hazards
that may be encountered.
en
15