Description; Accessories - Hilti GX 90-WF Manual De Instrucciones

Symbols
Read the Return waste
operating material for
instructions recycling.
en
before use.

2 Description

2.1 Use of the product as directed
The tool is for fastening wood to wood using specially
manufactured fasteners. The tool is suitable for use with
solid wood, laminated timber, plywood, chipboard ma-
terials (e.g. coarse oriented-strand board), fiberboard
materials (e.g. medium density fiberboard), and veneer
materials (e.g. Multiplex).
The tool is intended for use by professionals in the tim-
ber construction industry. For usage recommendations,
please consult the Hilti Fastening Technology Manual.
The tool, gas can and fasteners form a single technical
unit. This means that the tool can ensure optimum fasten-
ing performance only when used in conjunction with the
Hilti nails and gas cans that are specially manufactured
for it. The fastening and application recommendations
given by Hilti apply only when these conditions are ob-
served.
The tool is for hand-held use only.
The tool may be operated, serviced and repaired only by
trained personnel. This personnel must be informed of
any special hazards that may be encountered.
Modification of the tool is not permissible.

3 Accessories

Designation
Charger
Battery
Adapter for surface protection
Cleaning set
Sealing rings
Gas can
Nails
14
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when
used not as directed.
2.2 Items included in the delivery
2.3 System components for operating the tool
The following items are required to use the tool: Tool,
charged B7/1.5 Li-ion battery, GC 31 or GC 32 gas can
and GX-WF nails for wood joints.
Short designation
C7
B 7/1.5 Li‑ion
GC 31/GC 32
GX‑WF
1 Tool in plastic case
2 Batteries
1 Charger
1 Cleaning cloth
1 Eye protection
1 Ear protectors
1 Operating instructions
Description
Length: 50‑90 mm