Chicco TRIO LOVE Instrucciones De Uso página 16

Ocultar thumbs Ver también para TRIO LOVE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
FASTENING AND REMOVING THE CARRY COT IN THE
CAR
To install the CAR KIT, following the assembly instructions
below before positioning the carry cot in the car:
BUCKLES FOR CAR SEAT BELTS
23. To fasten the two buckles on the pins located at the
ends of the carry cot (fig. 23A), insert each buckle in the
pin pushing it (fig. 23B) and pulling the buckle down
until you hear a click (fig. 23C).
24. WARNING! Do not mount the buckles backwards!
(diag. 24).
The carry cot is now ready to be positioned in the car.
FASTENING THE CARRY COT IN THE CAR
25. To fasten the carry cot to the rear seat, position it at the
centre, aligned with the car seat, and fasten it using the
seat belts of the two outer seats (fig. 25).
26. If the rear seat of your car has a 3-point seat belt in the
middle seat too, the carry cot can be fastened also shift-
ed to one side occupying the middle seat and lateral
seat using the seat belts of these two seats (fig. 26).
27. Pull and fasten the two seat belts in the seat's buckles
(fig. 27).
Recline the carry cot backrest completely
WARNING! Never use the carry cot in the car with the
backrest raised! Safety is not guaranteed!
Follow the steps below on both sides:
28. Take the seat belt and make a loop (fig. 28);
29. Take the car kit buckle and rotate the buckle's red bar
outward (fig. 29).
30. Insert the loop you've made in the seat belt in the buck-
le (fig. 30A – 30B) and rotate the red bar to its initial posi-
tion so that it fits inside the loop (fig. 30C).
31. Pull the seat belt toward the retractor pressing the carry
cot against the seat so that it is fastened well (fig. 31).
WARNING! Make sure that the carry cot is fit against the
backrest and seat.
32. WARNING! Make sure that the belts are tensioned (fig.
32).
REMOVING THE CARRY COT FROM THE CAR SEAT
Follow the steps below on both sides.
33. Unfasten the buckle from the carry cot pulling the buck-
le's red tab outward and pushing (fig. 33) to release the
carry cot from the seat belt. The buckle is left fastened
to the seat belt.
WARNING! Never use the seat belt to fasten passenger
without removing the CAR KIT buckle: it can be dangerous!
34. To remove the buckle from the belt, loosen the loop in
the belt (fig. 34A) and rotate the red bar so that it comes
out (fig. 34B).
FASTENING THE CARRY COT TO THE STROLLER
Prepare the stroller to mount the carry out according to the
stroller's instructions.
WARNING: Before using the carry out on the stroller, the
safety harness must be fit under the mattress in the rel-
evant space (fig. 16A – 16B).
WARNING: To fasten the carry cot to the stroller structure,
remove the seat first.
35. Hold the handle in carrying position (vertical) and po-
sition the carry cot in the vertical joints until you hear
the click confirming fastening. Place the carry cot with
the baby's feet end facing the stroller's handle (fig. 35A).
To facilitate fastening the carry cot on the stroller, there
are labels with instructions on both sides of the fabric
showing you the correct alignment of the carry cot with
the fasteners (fig. 35 B).
WARNING: Before using, make sure that the carry cot is
properly locked on by pulling on it upwards.
REMOVING THE CARRY COT FROM THE STROLLER
Place the handle in carrying position (vertical)
36. Pull the button on the front of the carry cot (fig. 36A)
and keeping the button raised remove the carry out
from the stroller structure by pulling it up (fig. 36B).
WARNING: The fastening and releasing operations can be
carried out also with your child inside the carry cot; how-
ever, these operations may be more difficult to execute
with the child's weight. Pay attention when carrying out
the above mentioned operations.
Important Note: the images and instructions in this man-
ual refer to a single carry cot version. Some of the compo-
nents and functions described here may vary according to
the model purchased.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use.
The warranty shall not therefore apply in the case of da-
mages caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please
refer to the specific provisions of national laws applicable in
the country of purchase, where provided.
16
IM
T
T
E
B
R
A
EM
FA
D
A
• A
s
• A
c
s
l
s
m
• A
• A
s
f
• A
d
v
• A
s
c
• A
s
• A
p
e
C
• U
r
l

Publicidad

Tabla de contenido
loading

Tabla de contenido