Description - Hilti TE 80-ATC Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection hat
Wear Read the
breathing operating
protection instructions
before use.
Symbols
Return Hammer
materials for drilling
recycling
Volts Amps

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered combihammer with pneumatic hammering mechanism. The ATC (Active
Torque Control) function incorporated in the TE 80-ATC / TE 70‑ATC provides greater operating comfort while drilling.
The tool is designed for drilling in concrete, masonry, metal and wood and can also be used for chiseling.
Under certain conditions, the power tool is suitable for use for mixing (see "Tools, accessories" and "Operation").
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Observe the national health and safety requirements.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2.2 Chuck
TE‑Y (SDS max) quick-change "click" chuck
Wear ear Wear
protection protective
gloves
Chiseling Chisel
position
adjustment
Watts Alternating
current
Hertz Rated speed
under no
load
Double Equipped
insulated with theft
protection
system
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Type:
Generation: 01/02/02/02
Serial no.:
Revolutions Diameter
per minute
Lock symbol
15
en