Description - Hilti TE 30-A36 Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection hat
Wear
breathing
protection
Symbols
Forward / Read the
reverse operating
instructions
before use
Hammer Chiseling
drilling

2 Description

2.1 Use of the product as directed
The power tool is a cordless combihammer with a pneumatic hammering mechanism.
The power tool is intended for drilling in concrete, masonry, metal and wood. The power tool can also be used for light
to medium-duty chiseling work on masonry and for surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
To avoid hazards, only use the batteries and battery chargers recommended by Hilti for this power tool.
Do not use the battery as a power source for other unspecified appliances.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
Nationally applicable industrial safety regulations must be observed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
2.2 Chuck
TE‑C (SDS plus) chuck
TE‑T (SDS top) chuck
Wear ear Wear
protection protective
gloves
Return waste Drilling
material for without
recycling. hammering
Chisel Revolutions
position per minute
adjustment
Revolutions Millimeters
per minute
Volts Rated speed
Diameter
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Type:
Generation: 02
Serial no.:
Direct Amps
current
Watts Hertz
17
en