Turning Off The Machine - Smeg BCC02 Serie Manual De Instrucciones

time rotate the container (31) with slow
movements from the bottom upwards in
order to correctly froth the milk
The result of the steam function can
be influenced by the ingredients
used. For a good result, we
recommend using partially skimmed
milk or whole by removing it from
the fridge immediately before
pouring it into the container.
To avoid obtaining a little frothed
milk, or with big bubbles, always
clean the cappuccino cleaner
as described in the paragraph
"Cleaning and maintenance".
• The maximum continuous steam delivery
time is two minutes, if you want to stop the
delivery before the automatic stop, press
the button (19)
• After the automatic stop, steam delivery can
be restarted by pressing the button (19)
.
• After heating the milk, clean the inside of
the steam wand by dispensing steam for a
few seconds, making sure that the tray (14)
is fixed to the machine.
During steam delivery and after
delivery, the steam wand (30) is
hot; danger of scalding.
• Clean the steam wand every time you use
it, to avoid milk residues or clogging.
For a complete cleaning of the steam
wand see paragraph "Cleaning and
maintenance".
• A manual rinse cycle is recommended at
the end of each use of the steam function.
Use
(Fig.M).
again.
Customization of the quantity
It is possible to customize, for each type of dispensing,
the quantity of coffee or water dispensed.
• Place a cup or large cup under the
dispenser.
• Press for at least 3 seconds one of the
keys relative to the drink to be dispensed.
The selected key lights up flashing; the
machine emits a double sound to signal
the modification of the preset program.
• On reaching the desired quantity, stop
dispensing by pressing the key again; an
acoustic signal indicates the memorization
of the quantity.
Any customization of the drinks
remains saved for future dispensing.
To restore the manufacturer's settings,
press the keys (9)
simultaneously for at least
3 seconds.
The machine emits a single sound to
signal the restoration of the factory
settings.

Turning off the machine

• Check that the drip tray (14) is positioned
correctly.
• If there is no water, the machine remains in
the rinse position until the tank is filled.
• Press the button (9)
(18), (19) light up flashing in sequence and
the machine, if it has dispensed at least one
coffee, performs a self-cleaning cycle.
At the end of the self-cleaning cycle, the
machine switches off.
and (20)
, the keys (16), (17),
EN - 7