Maintenance; Daily, By A Trained User; Every 25,000 Loaves And/Or At Least Once A Year, By An Approved Agent; Blade Replacement - JAC VARIA VMP800 Manual De Instrucciones

8

MAINTENANCE

8.1

Daily, by a trained user

A. Check whether you need to empty the crumb tray (NB: don't forget to lock the door with the
key) (fig.1, n°8).
B. Clean the tables (fig.3, n°13, 15) using a brush.
C. Clean the cover window (fig.1, n°1) by placing it in the cleaning position (fig.9).
D. Use a dry cloth to clean the inside.
E. Use a damp cloth to maintain the outside.
F. Activate cleaning mode:
press the "brush" symbol in the top right-hand corner.
8.2

Every 25,000 loaves and/or at least once a year, by an approved agent.

A. Remove the plug from the socket (fig.2, n°12).
B. Check the condition of the cutting blade (fig.1, n°2).
C. If you notice a degradation in cutting quality, the cutting blade will need to be replaced (JAC
part number: BVSLCA030 in the JAC Spare Parts catalogue).
D. If the blade needs to be replaced, do so in accordance with the blade replacement procedure
(fig.7).
E. Clean with a brush and vacuum the inside of the machine.
Be sure to check that your approved agent has recorded his work in your service booklet in order to
maintain your 5-year warranty cover.
8.3

Blade replacement

(fig.7)
Be sure to wear cut-resistant gloves (Standard EN 388: 2003 factor B= 5) and safety footwear always
when replacing a blade or when working in the vicinity of the blades.
Having ensured that the plug on the machine (fig.2, n°12) has actually been disconnected from the
mains:
Open the door (fig.1, n°10) using the lock (fig.1, n°9).
Remove the crumb tray (fig.1, n°8).
Replace the blade:
A. Unscrew the two spanners located on the left-hand side of the machine (fig.7, n°23).
B. Remove the blade guard (fig.1, n°6) by means of the Allen screws.
C. Unscrew the nut that secures the blade (fig.7, n°24) using the two spanners supplied (fig.7,
n°23).
D. Remove the spacer and replace the blade, taking care to position it correctly on the locator
pins. Replace the spacer.
E. Fit and tighten the new nut supplied with the new blade to lock the blade, using the
spanners supplied. It is important that the new nut be fitted in order to ensure optimum
tightening.
Refit the crumb tray and close the door.
Connect the machine to the mains supply, it is now ready.
Be sure to check that your approved agent has recorded his work in your service booklet in order to
maintain your 5-year warranty cover.
Please note that your blade can be sharpened; contact your approved agent for further information.
English
12