Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1
MRA windscreen
4
Plastic discs 12x5x0.5mm
4
O-rings, 4.5x1.5mm
2
Distance sleeves 15mm
2
Distance sleeves 20mm
4
Fillister head screws, M5x30mm
1
Protective edge strip with
clamping sleeves
Mounting the windscreen onto the motorcycle:
1. Place the motorcycle on a flat surface.
2. Disassemble the original windscreen.
3. Take the MRA windscreen and insert the supplied 30mm fillister head
screws [10566] with the plastic washers [10635] through the top holes.
Then, place the 20mm distance sleeves [11181] against these from behind
and secure them with the small O-rings [10992].
4. Insert the 30mm fillister head screws [10566] with the plastic washers
[10635] through the bottom holes of the MRA windscreen and place the
15mm distance sleeves [10636] against them from behind. Secure these
with the small O-rings [10992] (P1 + P2).
5. Mount the MRA windscreen. Tip: First, turn all screws a few times before
carefully tightening all screws fully.
6. Apply the protective edge strip as shown in figure P3.
7. Push the clamping sleeves over the ends of the protective edge strip profile
and lightly press these together using a pair of pliers to secure the
protective edge strip profile.
After installation, check that all the screws are tight; tighten them up if necessary. Repeat this at regular
intervals. Clean the screen with water, neutral soap, and a sponge. Do not use solvents, alcohol, or spirits
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
KTM Super Adventure 1290 S R 2021-
Article No..
---
Torx TX 25, Allen key 3mm
10635
Torx TX 25, Allen key 3mm
10992
10636
11181
10566
---
3
Required tools
Publicidad
