Tabla De Contenido - Pioneer DEX-P99RS Manual Del Usuario

Contents
Connecting the units ............................. 2
Power cable connection diagram .................. 4
Example of connecting system 1 .................... 6
Example of connecting system 2 .................... 8
Installation ............................................ 10
DIN Front/Rear-mount ................................... 10
Removing or attaching the trim ring .................... 10
DIN Front-mount .................................................... 11
DIN Rear mount ..................................................... 11
Fastening the front panel .............................. 11
Installing the steering remote control ......... 12
Installing the unit on steering wheel............. 13
2
All manuals and user guides at all-guides.com
Connecting the units
WARNING
Please note the following when using
the auto time alignment and equalizer
(Auto TA&EQ).
Do not connect the high range speaker
(tweeter or super tweeter) other than to the
high range output terminal.
To measure the acoustic characteristics of
the vehicle cab, the auto time alignment and
equalizer (Auto TA&EQ) emits a loud sound from
the speakers. If the high range speaker (tweeter or
super tweeter) is connected to a speaker terminal
other than the high range output terminal, the
speaker may be damaged by the measuring
sound which includes low frequencies. Be sure
to connect the high range speaker to the speaker
output terminal for high signals.
Precautions when connecting a tweeter or
super tweeter
• Be sure to use the crossover network
provided with the super tweeter.
• The Auto TA&EQ may not be correctly
adjusted. Adjust manually, if necessary.
Note
• This unit cannot be installed in a vehicle that
does not have an ACC (accessory) position on the
ignition switch.
ACC position
• Use this unit in other than the following
conditions could result in fire or malfunction.
- Vehicles with a 12-volt battery and negative
grounding.
• To prevent short-circuit, overheating or
malfunction, be sure to follow the directions
below.
- Disconnect the negative terminal of the
battery before installation.
- Secure the wiring with cable clamps or
adhesive tape. To protect the wiring, wrap
adhesive tape around them where they lie
against metal parts.
No ACC position