Let's Communicate; Channel Selection; Volume Adjustment - Midland XT-10 Manual De Utilización

Let's communicate!

To turn on/off the radio
Hold down MENU/ for 3 seconds.

Channel selection

Press once the Menu button and then select the desired channel by the ▲/▼
buttons. Press PTT to confirm the selection. Remember that both radios must
be set on the same channel.
Transmission
Keep pressed the PTT button. "Tx" and "to" will blink on the display. Release the
PTT and the radio beeps to confirm to other users that your transmission has
finished ( 'Roger Beep', see paragraph).
Reception
Simply release the PTT button. When you receive a signal "Rx" is displayed.

Volume adjustment

Press the ▲/▼ to adjust the volume at the desired level.
button / CALL function
Keypad lock
This feature is very useful to avoid accidental pressure of the buttons. Press and
hold the " /CALL" button for more than 3 seconds. The confirms that the
keypad lock is activated. Only PTT and the long pressure of Menu will still be
active. Repeat the same procedure to unlock the keypad.
Sending an audio signal (CALL)
By pressing /CALL, you will send an audio signal to other users on the same
channel.
XT10 instruction guide | 7