Scan Function; Automatic Power Save - Midland XT-10 Manual De Utilización

Activation: Keep pressed MON/SCAN till the display shows "Rx".
Deactivation: Do the same procedure or switch off the radio

SCAN function

The SCAN mode monitors the busy channels.
It is used to check the traffic radio on all the channels before transmitting and
allows the unit to stop on a channel that someone is talking on. When the radio
stops on a busy channel, the scan will resume after about 5 seconds.
To activate the SCAN function
Push briefly MON/SCAN.
To deactivate it:
Press MON/SCAN or PTT.

Automatic power save

XT10 is supplied with an automatic current economy circuit. If the transceiver
receives no signal for more than 10 seconds, the "power save function" auto-
matically activates. The battery life may increase by up to 50 %.
10 | XT10 instruction guide