Publicidad
2X008ebk0.book Page 8 Friday, July 11, 2003 1:38 PM
9
10
F i g u r e 1 - 7 .
screws (2)
converter
board
chassis guide
pins (2)
1-8
Infor mation Update
All manuals and user guides at all-guides.com
Install the replacement converter board:
Align the holes in the board with the guide pins on the bottom of the chassis,
a
lower the board into the system, and slide the board forward 1 cm (0.5 inch).
Replace the two screws that you removed in step 8.
b
Install the replacement power supply by inserting the guide pins on the power supply
into the guide-pin slots on the chassis, lowering the power supply into the chassis, and
then pushing the power supply toward the front of the system. See Figure 1-7.
R e m o v i n g a n d R e p l a c i n g t h e P o w e r S u p p l y
power supply
power-supply cable
hard drive 3
plastic insert
power-supply
guide pins (2)
guide-pin slots (2)
Publicidad
