Publicidad
2X008ebk0.book Page 6 Friday, July 11, 2003 1:38 PM
12
F i g u r e 1 - 6 .
CERC card
13
14
15
16
1-6
Infor mation Update
All manuals and user guides at all-guides.com
Insert the CERC card firmly into the expansion-card connector on the riser board
until the card is fully seated, being careful not to disconnect the riser board from the
system board. See Figure 1-6.
I n s t a l l i n g t h e C E R C C a r d
expansion-card connector
(on riser board)
system board
Place the bottom edge of the cable into the guide slot directly under the connector on
the left side of the backplane (as viewed from the front of the system), and then attach
the cable to the connector on the backplane. See Figure 1-5.
Replace the plastic insert adjacent to the expansion slots. See Figure 1-4.
Align the blower assembly and fan assembly with the connectors on the system board
and the pegs on the chassis.
Push down on the blower assembly and fan assembly until they are properly seated on
the chassis pegs.
PCI slot 1
Publicidad
