Kettler KIDDI-O 8727 Instrucciones Para El Montaje página 3

USA ASSEMBLY INSTRUCTIONS
■ Replace worn or damaged parts immediately and ensure that the product is not used again
until this has been done. If any parts require replacement, use only original spares
manufactured by KETTLER®.
■ For models with pneumatic tires: tighten the valve caps at all times and keep them out of
Children's reach (choking hazard – contains small parts).
Use of the Toy
■ Ensure that the balance bike is not used until it has been properly assembled and checked by
an adult person.
■ Do not transport any objects on the balance bike.
■ Always adjust the use of the balance bike to the conditions encountered.
■ Balance bikes do not possess a continuously effective brake system. Therefore, safeguard
the balance bike against rolling away when parking it. Never park the balance bike unattended
with a child on it!
■ Never draw the balance bike behind you as long as a child is seated on it.
■ Instruct your child how to use the balance bike correctly and draw attention to possible
sources of danger.
■ Although dangerous situations are unlikely to occur if the balance bike is used correctly,
children at play should, if possible, be supervised.
■ Please bear in mind that there is always a danger of children injuring themselves while using
swings, climbing frames, toy vehicles or similar equipment.
■ When children are at play, situations may arise which cannot be predicted by the
manufacturer and for which he cannot be held responsible.
■ Before use, always check all screws and plug-in connections as well as respective safety
devices fit correctly.
■ Never use corrosive or abrasive substances to clean the balance bike. Never use substances
which may cause pollution of the environment.
■ For models with pneumatic tires: Due to the nature of materials used in pneumatic tires, it is
not recommended for the product to be left in any one place for too long where solvents or
other chemicals, i. e. oil, may lie. This may result in a chemical reaction, which could cause
the tires to mark the surface such as a vinyl flooring. If in doubt put something underneath the
wheels to cover the floor. Ensure that air pressure in the tires is correct; if air pressure is too
low this increases wear, and makes riding the balance bike more difficult!
■ Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every
two or three months.
3