Cleaning Carpets - Silvercrest SHBR 560 A1 Instrucciones De Uso

Fig. 14
Hold down the cleaning solution switch
cleaning movements with the appliance. This ensures that the cleaning solution is
applied evenly to the hard floor via the rotary brush.
NOTE
► For stubborn dirt, move the appliance over the soiled area several times
while holding down the cleaning solution switch
Press the hard floor switch

Cleaning carpets

NOTE
► Before using the appliance to clean a carpet, test the appliance on an
inconspicuous area of the carpet.
► Before cleaning, check the carpet manufacturer's label for special care
instructions. The appliance is not suitable for sensitive carpets (e.g. silk,
leather, flokati etc.).
Once the appliance is assembled and the fresh water tank
and cleaning solution:
Unwind the power cable
z/p
. To unwind the power cable
pull the upper cable retainer
fig. 16).
Insert the plug into the mains power socket.
Press the carpet switch
The LED on the carpet switch
■ 90 │ GB │ MT
Fig. 15
t
during both forward and backward
r
again to switch the appliance off (see fig. 13).
u
completely from the upper and lower cable retainers
u
quickly from the cable retainers
z
out a little way and turn it downwards (see
e
to switch the appliance on (see fig. 17).
e
lights up blue.
t
.
q
is filled with water
z/p
SHBR 560 A1
,