Worx WG775 Manual Del Usuario página 17

Remove the Grass Collection Bag and
shake the grass down to the back end of
the bag. Also clean out any grass or debris
which may be packed around the discharge
opening. Replace the Grass Collection Bag.
5) If mower should start to vibrate abnormally,
release Switch Lever to turn the mower
"OFF" and remove the Safety Key. Check
immediately for cause. Vibration is a
warning of trouble. Do not operate mower
until a service check has been made.
6. always release switch lever to turn
mower "off" and remove safety key
when leaving it unattended even for a
short period of time.
9. mUlCHiNg mOwiNg TiPs
When using the mulching plug, your new
mower is designed to cut the grass clippings
into small pieces and distribute them back into
the lawn. using mulching fins located inside
the mower deck. Under normal conditions,
the mulched grass will biodegrade quickly to
provide nutrients to the lawn. Please review
the following recommendations for optimum
mulching performance.
1) Avoid mowing when the grass is wet from
rain or dew. Wet grass may form clumps
which interfere with the mulching action
and reduce runtime. The best time to mow
grass is in the late afternoon when the
grass is dry and the newly cut area will not
be exposed to direct sunlight.
2) For best mulching performance, set the
cutting height to remove about one third
of the grass blade length, ideally no more
than 1.5" inches at one time. If the lawn is
overgrown, it may be necessary to increase
the cut height to reduce the pushing effort
and prevent overloading the motor. For
extremely heavy mulching, it is advisable
to first cut at a high cut height setting,
and then re-cut to the final cut height.
Otherwise, make narrower cuts and mow
slowly.
3) For best performance, keep the mower
housing free of built-up grass. From time to
time, turn off mower and wait for the blade
to come to a complete stop. Then unplug
the Safety Key (6) and turn mower on its
3-in-1 Cordless lawn mower
All manuals and user guides at all-guides.com
4) Certain types of grass or grass conditions
5) Change your cutting pattern from week to
mAINTENANCE
removing the grass bag.
NOTE:
To ensure long and reliable service, perform
the following maintenance procedures
regularly.
•
•
•
•
bladE (16) sHarPENiNg
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT
CUT GRASS CLEANLY OR MULCH PROPERLY.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS
REMOVED.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly. If your lawn has sandy soil, more
side. Using an object such as a stick, wipe
out any accumulation of grass in the blade
area. Be careful of the sharp edges of the
blade. Clean often in wet, new grass, and
always after every use.
may require that an area be mulched a
second time to fully disperse the grass
throughout the lawn. If cutting a second
time, it is advisable to cut perpendicular
(across) the first cut pattern. DO NOT
CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
week. This will help prevent matting and
graining of the lawn.
warNiNg: stop the mower and
remove the safety key before
Check for obvious defects such as a loose,
dislodged or a damaged blade, loose
fittings, and worn or damaged components.
Check that the covers and guards are all
undamaged and are correctly attached to
mower.
Carry out any necessary maintenance or
repairs before operating mower.
If the mower should happen to fail despite
regular maintenance, please call our
customer helpline , 1-866-354-9679.
17
EN