SEA SATURN 24V 600 Manual Del Usuario página 11

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
5. RELEASE SYSTEM
5.1. In order to release do as follows:
-Open the lock cover, insert the key and rotate it 90° clockwise
(Fig. 6).
- Pull the release lever until it stops, about 90° approximately
(Fig. 7).
Note: when you pull the release lever, the electronic control
unit receives a stop impulse thanks to a micro-switch
placed inside.
5.2. In order to relock do as follows:
- Push the release lever to complete closing.
- Rotate the key counter-clockwise and extract it.
- Close the protective lock cover.
Once the lock has been restored the electronic control unit
reactivates
l C o s e
6. GEAR RACK MOUNTING
6.1. Release the motor reducer and take the leaf to complete
opening;
6.2. Fix to each gear rack element the support pawls using the
appropriate lock screws, taking care to place them in the upper
part of the hole (Fig. 8) ;
6.3. Lean the gear rack element on the toothed pinion of the
motor so that it results parallel to the ground slideway of the
gate, place it as shown in Fig. 9 and electrically weld the central
pawl B to the gate structure (Fig. 10).
cod. 67410326
®
O p e n
Fig. 8
Manually move the gate until pawl C is placed in
correspondence to the pinion, now fix it with electric welding.
Repeat the same procedure for pawl A after having placed it in
correspondence to the pinion;
A
Fig. 6
Fig. 10
6.4. Make sure that all the gear rack elements are perfectly
aligned and placed correctly (teeth in phase). It's suggested to
place two aligned elements infront of a third one as shown in
Fig.11;
6.5. Repeat the above described operation for all the remaining
gear rack elements which have to be installed;
6.6. To avoid that the door weights down on the pinion (Fig.12)
lift up the whole rack about 1,5 mm.
Warning: Keep a gap of about 0,5 mm between pinion tooth
and gear rack tooth;
6.7. Make sure that the gear rack works at the center of the
pinion along all rack elements, if necessary, adjust the distance
pieces length.
Fig. 7
Fig. 11
1,5 mm
REV 01 - 07/2008
B
C
Fig. 9
Fig. 12
11/33