Manually Starting The Firmware Update Mode - Oase FM-Master WLAN Instrucciones De Uso

Malfunction
The yellow LED is flashing slowly (2 seconds
on, 1 second off).
Red LED is flashing.
The device does not start, red LED flashing.
8.2

Manually starting the firmware update mode

How to proceed:
 J
1. Disconnect from the power supply.
2. Remove the plug.
3. Insert the service pin into the opening between the two top sockets until you feel a resistance. That is the
reset button.
4. Hold down the reset button.
5. Connect to the power supply again while pressing the reset button.
6. Release the reset button after approx. 2 seconds.
The FM-Master WLAN is in firmware update mode when the yellow LED is flashing.
7. Use your smartphone/tablet to establish a WLAN connection with the WLAN OASE_UPDATE_XXXXXX or
OASE_UPDATE_EGC_XXXXXX.
8. Start the firmware update via the app. (→ Updating the firmware)
9. Reinsert the plug.
Cause
FM-Master WLAN is searching for a connection to
the router.
Internal error
No firmware found.
Remedy
Reduce the distance, do not exceed the
max. range of 80 m.
Remove any sources of interference that
may be weakening the WLAN signal (e.g.
other wireless devices, differences in
height).
Switch on the WLAN router.
Activate the WLAN function on the router.
If the router is no longer available or defec-
tive, reset the network settings of the FM-
Master WLAN so that it can be directly
controlled in access point mode
(→ Resetting the network settings)
Connect the FM-Master WLAN to another
router (→ Establishing a connection via
WLAN router)
Disconnect from the power supply, wait for
10 seconds and then reconnect.
Reset the FM-Master WLAN to the factory
default settings.
Manually start the firmware update mode
(→ Manually starting the firmware update
mode)
- EN -
77