Tools Needed - Schumacher Electric SE-1555A Manual Del Usuario

9. ASSEMBLY INSTRUCTIONS
9.1 It is important to fully assemble your charger before use. Remove all cord wraps
and uncoil the cables prior to using the battery charger. Follow these instructions
for assembly.
(2) 10-32, thread cutting screws
(4) ¼-20, thread cutting screws
(4) Phillips head sheet metal screws
(2) wheels
(1) axle
(2) axle caps
(2) axle brackets
(1) handle
(1) foot
Assemble the Wheels and Axle: Hold the axle upright
on the floor or work surface. Then, using a hammer, tap
one of the axle caps onto the top end of the axle. Be sure
to tap the axle cap on straight. Slide both wheels onto the
axle with the recessed hubs facing out as shown. Install the
second axle cap.
Attach the Handle: If the charger came with a plastic grip, slide that onto
the handle until it is centered at the top. Turn the charger right side up
onto its foot and wheels. Align the handle so the screw holes are aligned
with the screw holes on the upper back corners of the charger. Attach the
handle using the four Phillips head screws provided.
All manuals and user guides at all-guides.com
PARTS
Attach the Foot: Remove the charger from the packing materials and
place upside down on a flat surface. Attach the foot and secure it with
the four ¼-20 thread cutting screws provided.
•

TOOLS NEEDED

3/8" wrench (for mounting foot)
5/16" wrench (for mounting wheels)
hammer
screwdriver (flat blade)
screwdriver (Phillips)
Mount the Axle to the Charger: Place one end
of each bracket into the slot on the bottom of the
charger. Place the axle assembly under each
bracket. Attach the brackets using the two, 10-32
thread cutting screws provided.
NOTE: Be careful not to drop the brackets inside
of the charger case.
5
•