Edenwood CURVE SYSTEM 18P Manual Del Usuario página 32

B
Product usage
3. When the Bluetooth device displays the speaker system's Bluetooth name - EDENWOOD
CURVE SYSTEM 18P - select this name and confirm the pairing process.
4. BLUE will stop flashing when the devices have paired.
NOTE:
• Before connecting a Bluetooth device to this system, make sure you are
familiar with the device's functions.
• If the system's Bluetooth name does not appear on your Bluetooth device,
move the devices closer together. If that doesn't work, turn the devices off
and back on again before restarting the pairing process.
• When pairing the devices, make sure they are less than 15 metres apart and
there are no physical obstructions between them.
• Once paired, the devices should remember the connection and you shouldn't
need to pair them again.
• Compatibility with all Bluetooth devices is not guaranteed.
• If the signal strength is weak, your Bluetooth receiver may disconnect. If no
USB stick is connected, the system will automatically re-enter pairing mode.
If a USB stick is connected, it will automatically start playing tracks from
the USB. In this instance, remove the USB stick from the system to continue
using the Bluetooth function.
Mains power supply and fuse
Warning!
• Select the correct voltage that corresponds to the power source (and fuse
rating) before connecting the system to the power source.
• Only use the correct voltage, otherwise you risk damaging the system and/or
injuring yourself and voiding the warranty.
• Before plugging in and switching on the speaker system, make sure that all
the controls are turned off or set to the minimum level.
Connecting the speaker system to a power source
Once all your speaker system's connections have been set up, you can connect the subwoofer/
amplifier to the mains power supply.
1. Connect one end of the power cable to the system's AC socket and the other end to the
mains socket.
2. Slide the MAIN POWER SWITCH to the I position. The POWER LED INIDCATOR will turn on.
31 EN