Connections - Edenwood CURVE SYSTEM 18P Manual Del Usuario

B
Product usage
Place the 4 speakers on the ground with the back of the speakers facing upwards.
Align the line array mount with the screw holes on the back of each speaker. Insert
the 8 screws and tighten them with the Allen key.
Once assembled, connect the 3 line array cables in the indicated configuration.
Unscrew and remove the knob on the line array mount. Align the hole in the metal
mounting bracket with the hole on the line array bracket. Insert and tighten the knob
to secure the metal mounting bracket in place.
NOTE: Please insert the metal mounting bracket as shown in the diagram.
Unscrew the metal mounting bracket's knob anticlockwise and mount the line array
onto the tripod. Turn the knob clockwise to secure it firmly in place.
Repeat the process to assemble the second line array.

Connections

IMPORTANT!
• Before adding or changing connections, make sure that all parts of the speaker
system have been disconnected from the power supply and all the controls
are off or set to the minimum level.
Connecting an audio source to the line arrays and adding a speaker
To increase the performance of your audio source unit (i.e. any 350-500 mV stereo device),
connect the source unit with the subwoofer (equipped with a built-in amplifier) and the
line arrays, in addition to an additional speaker (if desired).
1. Connect the audio source unit to the BALANCED XLR/TRS INPUT connectors via an XLR
or ¼" TRS input (cables not provided).
2. Connect the speaker line arrays to the SPEAKER OUPUT (LEFT CH) and SPEAKER OUTPUT
(RIGHT CH) connectors using the two 6 m ¼" TRS cables provided.
3. Connect an additional speaker to the BALANCED XLR OUTPUT connector.
NOTE: The XLR output connectors are only active when the XLR/TRS inputs are
in use.
Connecting a mixer
To fine-tune the sound settings, connect a mixer to the speaker system.
1. Connect the mixer to the BALANCED XLR/TRS INPUT connectors via a ¼" XLR/TRS cable.
2. As described above, connect the line arrays and an additional speaker, if desired.
29 EN