Publicidad
Idiomas disponibles
Idiomas disponibles
16 | O RB EA
0 7 EXTE RNA L BAT TE RY R S
RA NG E EXTE ND E R
If Rise was On when connecting the Range
Extender to the bicycle, the system will turn
itself Off and you will need to turn Rise On
again by pressing the power button.
This happens so the system can reboot and
recognize the Range Extender as part of the
power system when Rise is turned On again.
If you were recording an activity with Garmin
Connect using Orbea RS Toolbox, this will
have no effect on the data recorded in the
activity. The Rise data will keep registering
when you start using Rise again.
Once you turn Rise on, the Range Extender
will be operative. It is not necessary to turn
the Range Extender On.
If the Range Extender is disconnected when
the bicycle is On, the bicycle will turn itself
Off and it will be necessary to turn the bicy-
cle back on. This happens so the system can
reboot and recognize the internal battery as
the only current power supply.
RANGE EXTENDER ASSEMBLY
1. Install the Range Extender dedicated mount onto the
downtube and fix it in place with the original bolts with
a recommended torque setting of 5 Nm.
2. When installing the Range Extender holder, remove the
four washers pre-installed on the frame and make sure
that, once installed, the Range Extender´s six contact
points rest correctly against the downtube.
3. Install the Range Extender into the mount and secure it
with the side o-ring.
The Range Extender bottle holder is compatible
with standard bottles when the Range Extender is
not installed.
QUICKSTART GUI DE
1
3
5 N.m
2
x6
3
R ISE · H YDRO 2022
CONNECTING THE RANGE EXTENDER
TO RISE HYDRO
1. Turn the safety tabs of the Range Extender cable coun-
ter-clockwise before connecting it to the battery.
2. Connect the cable to the Range Extender charging port.
Open the bicycle charging port and connect the Range
Extender cable.
3. Turn the cable´s safety tabs clockwise to lock the cable
in place.
To disconnect the Range Extender cable or to remove
the Range Extender from the bicycle to charge it, turn
first the cable´s safety tabs and carefully pull from the
cable´s connector.
1
3
If Rise was On when connecting the Range
Extender to the bicycle, the system will turn
itself Off and you will need to turn Rise On
again by pressing the power button. This hap-
pens so the system can reboot and recognize
the Range Extender as part of the power sys-
tem when Rise is turned On again.
If you were recording an activity with Garmin
Connect using Orbea RS Toolbox, this will
have no effect on the data recorded in the
activity. The Rise data will keep registering
when you start using Rise again. Once you
turn Rise on, the Range Extender will be op-
erative. It is not necessary to turn the Range
Extender On.
If the Range Extender is disconnected when
the bicycle is On, the bicycle will turn itself
Off and it will be necessary to turn the bicy-
cle back on. This happens so the system can
reboot and recognize the internal battery as
the only current power supply.
2
2
ORBEA | 17
EN
1
3
Publicidad
