Sauder Dakota Pass 419440 Instrucciones De Montaje página 7

Step 3
NOTE: Do not peel the backing completely off of the FELT STRIP (84M).
å
Partially peel the paper off the back of the FELT STRIP (84M), giving yourself enough of the FELT STRIP to cover the fi rst
å
couple of inches of the BARREL REST (G).
IMPORTANT: Do not pull tightly on the FELT STRIP as you apply it to the BARREL REST. Pulling the strip tight as you apply
å
it will cause the felt to separate from the edge of the board.
Apply the FELT STRIP (84M) to the BARREL REST (G). Start the exposed end of the FELT STRIP at one end of the
å
BARREL REST and fi rmly press, do not pull, on the FELT STRIP. Work your way down the BARREL REST. Trim any excess
FELT STRIP off with your scissors.
NOTE: When pulling back the release paper on the FELT STRIP, be sure you do not pull on any of the FELT STRIP already
å
applied to the BARREL REST.
Tap two MOLDING CONNECTORS (17F) into the notches in the FRONT LEGS (L and M).
å
Flat end
Flat end
17F
www.sauder.com/services
17F
Use your hammer to tap the MOLDING CONNECTORS (17F)
into the notches in the FRONT LEGS.
L
M
419440
G
84M
Page 7