To Start The Engine - McCulloch B40 B Elite Manual Del Usuario

the cutting attachment sufficiently and you must
replace it.
• Examine the blade guard for damages or cracks.
Replace the blade guard if it has been hit or if it has
cracks.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.

To start the engine

1. Put the product on a flat and stable surface. Keep
the cutting attachment off the ground.
2. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
3. Move the choke lever to the choke position.
1681 - 001 - 28.06.2021
WARNING:
starts to rotate immediately when you
start the engine with the choke.
4. Set the start/stop switch to the RUN position.
5. Hold the body of the product on the ground with your
left hand.
6. Hold the starter rope handle with your right hand.
7. Slowly pull out the starter rope with your right hand
until you feel some resistance.
WARNING:
rope around your hand.
8. Pull the cord quickly and with force. Pull the starter
rope again and again until the engine starts.
CAUTION:
rope to full extension and do not let go of
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
9. Reset the choke when the engine fires.
10. Operate the throttle gradually when the engine
starts.
11. Make sure that the engine runs smoothly and let the
engine become warm for 1-2 minutes before
operation.
The cutting attachment
Do not twist the starter
Do not pull the starter
17