Joie allura 120cm Manual De Instrucciones página 5

WARNING
!
Adult assembly required.
!
Please save instruction manual for future reference.
!
Read all the instructions in this manual before using product.
!
Discontinue using travel cot when child reaches 15 kg (approximately 86 cm in height) or is able to
climb out.
!
Discontinue using bassinet when child can sit, kneel or roll over or pull itself up.
!
The lowest position of the mattress is the safest and the base shall always be used in that position as soon
as the baby is old enough to sit up.
!
Failure to follow these warnings and instructions could result in danger.
!
DO NOT make any modifications to this travel cot or use it with component parts from other manufacturers.
!
DO NOT use the travel cot if any parts are broken, torn or missing.
!
NEVER leave your child unattended. Always keep your child in view.
!
Use the travel cot with only one child at a time.
!
Do not use more than one mattress in the travel cot.
!
Once the bassinet is installed, DO NOT place child under the bassinet.
!
DO NOT leave anything in the travel cot or place the travel cot close to another product, which could
provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blind curtain cords etc.
!
Always use travel cot on a flat, level floor.
!
Be aware of the risk of open fire and other sources of strong heat such as electric bar fires, gas fires, etc in
the vicinity of the travel cot.
!
To avoid strangulation, DO NOT place items with a string around your child's neck, suspend strings from this
product, or attach strings to toys.
!
All assembly fittings should be unfolded completely and tightened properly before using the product.
!
Regularly check the locks and fittings for security.
!
Regularly inspect the product for damaged hardware, loose joints, missing parts or sharp edges.
!
DO NOT move the travel cot with your child in it.
!
Make sure the product has been folded or unfolded completely before letting your child approach
the travel cot.
!
You must attend to your child while it is in the bassinet. Do not place the bassinet in a dangerous place.
!
For safe fitting the mattress must not be less than 1180 mm in length and 610 mm in width. The length and
width must be such that the gap between the mattress and the sides and ends does not exceed 30 mm. The
thickness of the mattress must not be more than 25 mm, that the internal height ( the distance from the top
of the mattress to the upper edge of the product side ) is at least 500 mm in the lowest position of the travel
cot and at least 200 mm in the highest position of the travel cot.
!
Do not replace Joie mattress with other mattress or soft pad.
!
Should the padded rim be split or bitten through to expose the padding, do not use the travel cot.
!
The four side rails and mattress must be unfolded and secured completely before using the product.
!
Always keep accessories out of child's reach. Remove the accessories when child is able to pull itself up in
the travel cot.
!
DO NOT use the bassinet as a napper before assembling with mattress.
7
! DO NOT store the bassinet in the travel cot while not in use.
!
You must follow the instructions in this manual when using the travel cot and the bassinet.
!
To avoid suffocation, remove plastic bag and packaging materials before using this product. The plastic bag
and packaging materials should then be kept away from babies and children.
!
Do not install or hang the playard to fixed or unfixed frame.
!
Always make sure to close the opening by the zipper before placing the child into the travel cot.
Travel Cot Assembly
-
see images
1 6
Please read all the instructions in this manual before setting up and using this product.
1. Undo the three hook and loop fasteners.
1
2. Pull the top rails up until both become rigid. If not rigid, pull up again until they are rigid.
!
If top rails do not latch, raise the center of floor halfway up, and then pull up again to latch the rails.
3. Latch the low rails.
3
4. Push the center of floor down. 4
! Be sure all rails have locked before lowering center.
5. Install mattress.
5
!
Install mattress, soft side up.
! - 1
Use wheels, see images 5
6. Thread the loop fastener through the fabric loop on the mattress, and then stick to the hook fastener.
Fold Travel Cot
see images -
11
7
7
1. Remove the mattress.
2. Pull the folding webbing upward. 8
!
Do not unlock rails yet. Center of floor must be halfway up before rails will unlock.
3. Unlock all four rails by following these steps.
1) Slightly lift the center of the rails. 9
2) Squeeze the latch button on the rail to release the two tubes.
!
Do not force fold.
!
Both tubes must be released for the rail to fold, if rail does not fold completely, please lift the center of
floor higher, and then try again from step 3.
4. Fold the unit, but do not force. 10
!
If unit will not fold, look for a partially latched rail. Squeeze the latch button to release the rail.
5. Wrap the travel cot with the mattress. Guide the hook and loop fasteners through the rings
and attach them. 11
2
6
9
8