Descargar Imprimir esta página

Agri-Fab 45-0587 Manual De Instrucciones página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
ADJUSTABLE SPRAY GUN NOZZLE
Twisting the nozzle will adjust the spray pattern from a cone shaped
mist to a solid stream.
BEFORE STARTING
1. Attach the sprayer to the tractor hitch.
2. Connect the wire harness from the switch to the pump.
3. Check for leaks using plain water. Fix leaking fittings with thread
tape.USING THE SPRAYER
CAUTION: Wear eye and hand protection and protective
clothing when handling and working with lawn chemicals.
1. Determine the application rate (gallons per 1,000 sq. feet) based on
the chemical manufacturers recommendations.
2. Estimate the size of the area to be sprayed and the amount of
solution that will be needed. This can help avoid unneeded solution
left in the tank.
3. Refer to the application chart below to help determine the speed
required to achieve the manufacturers recommended application
rate.
4. Use plain water to set the correct boom spraying pressure. Turn the
boom valve to the "ON" position. If misting occurs, gradually start
closing the valve until misting stops.
5. Add the chemical solution to the tank, following the manufacturers
recommendations.
6. Unfold Boom arms (25 gallon model only). Check height of spray
tips to ground (A) is approximately 17" (43 cm). If necessary, adjust
boom height by raising or lower the boom on the threaded boom
supports (B).
A
B
7. Begin spraying, making each pass so that the spray pattern slightly
overlaps the spray pattern from the previous pass.
8. Stay clear of flowers, shrubs and evergreen trees when spraying to
prevent contact of the solution with these sensitive plants.
APPLICATION CHART
Sprayer
Tip Size
25 Gallon
TP11008VP
15 Gallon
PSI
GMP One Nozzle
30
0.69
35
0.75
Sprayer
2 mph
25 Gallon
1.57
15 Gallon
1.7
USING THE SPRAY GUN
1. Shut off the boom by turning the boom valve to "OFF".
SPRAYER RECIRCULATION
1. The sprayer is equipped with a recirculation valve to aid in material
agitation and pressure control.
2. This valve is in the "open" position when the valve handle is in line
with the hose (pictured), "closed" when perpendicular to the hose.
3. Adjusting the recirculation valve between the open/closed positions
will affect the pressure coming through the spray wand only.
4. Closed position is full pressure through spray wand or boom.
5. It may be helpful to adjust the pressure when spraying with the
spray wand to avoid damage to plants from excess pressure.
6. This valve should be in the "closed" position when operating the
boom.
MAINTENANCE
AFTER EACH USE
1. Fill the sprayer part way with water and pump the water out through
the boom assembly and the handgun. Use the handgun to wash
the inside of the tank.
2. Refill the tank about half full with water and a chemical neutralizer
solution and repeat the cleaning instructions above. Follow the
manufacturers instructions for disposal of all chemicals.
AS NEEDED
1. Periodically clean the tank strainer on the end of the intake hose.
Remove the nylon swivel nut from the hose, pull out the screen and
flush it with water.
2. Periodically clean the strainers in the boom nozzles. Remove the
nozzle, pull out the screen and flush it with water.
WINTER STORAGE
1. Drain all water out of the sprayer, especially the pump and
handgun. These items are prone to damage from freezing
temperatures.
2. Winterize the sprayer by pumping a 50-50 solution of water and
R. V. antifreeze through the boom assembly and the hand gun.
5
Gallons per 1000 Sq. Ft.
3 mph
4 mph
5 mph
1.05
0.78
0.63
1.13
0.85
0.68
6 mph
0.52
0.57

Publicidad

loading

Este manual también es adecuado para:

45-0588