Adjust Telescopic Arm; Operating The Long-Handle Hedge Trimmers; Cleaning And Maintenance; General Cleaning Work - Grizzly Tools EKHS 500-45 2in1 Traducción Del Manual De Instrucciones Original

Adjust telescopic arm

The telescopic tube (4) can be adjusted
continuously.
1. Loosen the retaining screw
of the telescopic tube (3) and
change the length of the tel-
escopic tube (4) by pushing and
pulling.
2. Fix the retaining screw (3) per-
manently in place.
Operating the long-handle
hedge trimmers
ANGLING THE CUTTING HEAD
To cut sloping edges or the top of the
hedge, the cutting head can be swivelled
into 6 positions.
Press the locking knob (21) and
simultaneously swivel the cutter
head (2). This locks into the de-
sired position when the lock but-
tons are released.
WORKING INSTRUCTIONS:
• While cutting, make sure that you do
not touch any objects such as wire
fences or plant supports. This can
cause damage to the cutter bar.
• If the blades become jammed with
solid objects, turn the device off im-
mediately and remove the object.
• Do not cut with blunt or worn blades,
as otherwise you will overload the
motor and gears of your machine.
• Carry the device with the cutting unit
facing backwards. Attach the blade
guard during transport.
CUTTING TECHNIQUES
• Cut thick branches beforehand using
a branch clippers.
• The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or
up and down in an arc movement.
• In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge,
so that cut branches fall to the
ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not de-
scribed in this manual. Only use
OEM parts. Risk of injury!
Pull out the power plug before car-
rying out any work on the equip-
ment.
Wear cut-protection gloves while
working with the cutting unit.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

General Cleaning Work

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
GB
63