GB
Overview
1 Blade safety bar
2 Cutter head
3 Retaining screw of telescopic tube
4 Telescopic tube
5 Operating unit
6 Tension relief
7 Handgrip
8 On/off switch
9 Switch lock
10 Operating unit lock
11 Eyelet for shoulder strap
12 Allen key
13 Cutting head lock
14 Front handgrip
15 Blade guard
16 Shoulder strap
Functional description
The
telescopic handled hedge trimmer
driven by an electronic motor. The equip-
ment is double-insulated for safety and
does not require earthing.
The unit is equipped with a double-sided
safety cutter bar. When cutting, the blades
move backwards and forwards in linear
motion. The impact protection at the end
of the cutting bar prevents unpleasant re-
bounds when touching walls, fences etc.
The unit can only be operated with the
deadman switch depressed, in order to
protect the operator. In addition, the hand
guard protects against branches and
briars.
Refer to the following descriptions for a
functional description of the controls.
Technical data
Electric combination
hedge trimmer
...........EKHS 500-45 2in1
Input voltage rating ......230-240V~, 50 Hz
56
Input power .....................................500 W
Blade speed............................. 1500 min
Safety class .......................................
Degree of protection ......................... IPX0
Weight ............................... approx. 4.3 kg
telescoped ......................... approx. 6.0 kg
Length of blades .......................... 480 mm
Cutting length .............................. 410 mm
Cutting capacity ............................. 18 mm
Acoustic pressure level
(L
) ........... 88.57 dB(A); K
pA
telescoped ..........................92.23 dB(A)
Sound power level (L
measured ...96.53 dB(A); K
guaranteed .............................102 dB(A)
measured, telescoped ..........95.95 dB(A)
Vibration (a
at the handle ........................ 2.254 m/s
telescoped ............................. 1.384 m/s
at the additional handle ........ 1.758 m/s
telescoped ............................. 1.308 m/s
is
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity. Technical and optical changes
may be undertaken in the course of further
development without notice. All dimen-
sions, references and information in this
instruction manual are therefore not guar-
anteed. Legal claims made on the basis of
the instruction manual can therefore not
be considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use
)
wA
)
n
-1
II
=3.0 dB(A)
pA
=3.0 dB(A)
wA
2
2
2
2
K=1.5 m/s
2