Duronic IRT3W Manual De Instrucciones página 26

Do not use hot steam or ultraviolet radiation for disinfection.
Otherwise, the thermometer may be damaged or quickly aged.
It is recommended to disinfect the thermometer before and after
each use. The disinfection time is completed within 1 minute, and
the number of repetitions per disinfection is not more than 2 times.
Clean and disinfect the thermometer under the temperature of
+10ºC~+40ºC (50ºF-104ºF), the relative humidity of 15%~85%RH (no
condensation) and the barometric pressure of 86kPa~106kPa.
To prolong the life of your IRT3W thermometer and ensure that it is
always ready and safe to use, please do the following on a regular basis:
• Check whether it has any potential safety hazards, e.g. whether the lens is
broken, the casing has cracks or if the sensing head is polluted.
• Do not use the thermometer if it is damaged as this is a potential safety
hazard.
• Clean the thermometer if not used for a long time.
• After each use, clean the temperature probe as described in the "Cleaning
and Disinfection" chapter.
• Store the thermometer in a dry, dust-free, and well-ventilated place. Make
sure that the thermometer is not exposed to direct sunlight.
• Remove the batteries if the thermometer will not be used for more than
two months.
Maintenance
25