Speaker Connections; How To Connect - Teac A-1D Manual Del Usuario

A
B
4
FRONT FRONT
Connections (1)
CAUTION
Turn off the power of all the equipment before making
connections.
Read instructions of each component you intend to use with this
unit.
< Be sure to insert each plug securely. To prevent hum and
noise, do not bundle the connection cords with the power cord
or speaker cord.

Speaker Connections

Caution:
To avoid damaging the speakers by inputting a sudden high-level
signal, be sure to switch the power off before connecting the
speakers.
< The amplifier's red speaker terminals are the + (positive)
terminals and the black terminals are the _ (negative)
terminals.
The + side of the speaker cable is marked to make it
distinguishable from the negative side of the cable. Connect
this marked side to the red + terminal and the unmarked side
to the black _ terminal.
< Prepare the speaker cords for connection by stripping off
approximately 10 mm or less (no more as this could cause a
short-circuit) of the outer insulation.
Twist the wires tightly together to avoid tangles :

How to connect

1 Turn the terminal cap counterclockwise to loosen it. The
speaker terminal caps cannot be fully removed from the base.
2 Insert the wire into the terminal fully and turn the terminal cap
clockwise to securely connect it :
3 Make sure it is fastened firm by pulling the cable lightly.
ENGLISH
A
B