Speaker Connections; How To Connect - Teac A-L700P Manual Del Usuario

Caution:
To avoid damaging the speakers with a sudden high-
level signal, be sure to switch the power off before
connecting the speakers.
Check the impedance of your speakers. Connect
speaker with an impedance of 6 ohms or more.
The red speaker terminals are + (positive), and the
black terminals are _(negative).
The + side of the speaker cable is marked to make it
distinguishable from the _ side of the cable. Connect
this marked side to the red + terminal and the
unmarked side to the black terminal.
Prepare the speaker cords for connection by stripping
off approximately 10 mm or less (no more as this could
cause a short-circuit) of the outer insulation.
Twist the wires tightly together so that they are not
straggly :
6
SURROUND
SPEAKER
A-L700P

Speaker Connections

SURROUND
SPEAKER
CENTER
SPEAKER

How to connect

1 Turn the terminal cap counterclockwise to loosen it.
The speaker terminal caps cannot be fully removed
from the base.
2 Insert the wire into the terminal fully and turn the
terminal cap clockwise to securely connect it.
3 Make sure it is fastened firm by pulling the cable
lightly.
ENGLISH